Wiki source code of How to set the transmit time interval
Version 5.1 by Edwin Chen on 2022/05/12 11:17
Show last authors
| author | version | line-number | content |
|---|---|---|---|
| 1 | |||
| 2 | |||
| 3 | = 1. Introduction = | ||
| 4 | |||
| 5 | This chapter describes how to set Transmit Time Interval for [[Dragino Sensors>>Dragino Sensors||anchor="End Device AT Commands and Downlink Command/#H4.1ChangeUplinkInterval"]]. | ||
| 6 | |||
| 7 | = 2. via AT Command through UART interface = | ||
| 8 | |||
| 9 | |||
| 10 | |||
| 11 | = 3. via LoRaWAN Downlink = | ||
| 12 | |||
| 13 | TDC can be controlled by Downlink Payload. | ||
| 14 | |||
| 15 | ((( | ||
| 16 | For example: AT+TDC=0x258=600s Payload: 01 00 02 58 TDC=600s The time interval is represented by hexadecimal conversion to decimal. | ||
| 17 | ))) | ||
| 18 | |||
| 19 | [[image:https://wiki.dragino.com/images/8/8e/TDC.png||alt="TDC.png" height="173" width="850"]] | ||
| 20 | |||
| 21 | ((( | ||
| 22 | |||
| 23 | ))) | ||
| 24 | |||
| 25 | ((( | ||
| 26 | If the payload=0100003C, it means set the END Node’s TDC to 0x00003C=60(S), 3C (HEX) = 60 (decimal)，while type code is 01. | ||
| 27 | ))) | ||
| 28 | |||
| 29 | ((( | ||
| 30 | Payload: 01 00 00 1E TDC=30s Payload: 01 00 00 3C TDC=60s | ||
| 31 | ))) | ||
| 32 | |||
| 33 | [[image:image-20220512084801-1.png]] | ||
| 34 | |||
| 35 | = 3. Downlink Method = | ||
| 36 | |||
| 37 | See use note for different serves [[Servers Note>>http://8.211.40.43:8080/xwiki/bin/view/Main/]] |