How to set the transmit time interval
Version 9.1 by Edwin Chen on 2022/05/12 11:31
1. Introduction
This chapter describes how to set Transmit Time Interval for label.
2. via AT Command through UART interface
AT+TDC | ||
---|---|---|
Command Example | Function | Response |
AT+TDC=? | Show current transmit Interval | 30000 OK the interval is 30000ms = 30s |
AT+TDC=60000 | Set Transmit Interval | OK Set transmit interval to 60000ms = 60 seconds |
3. via LoRaWAN Downlink
TDC can be controlled by Downlink Payload.
For example: Payload: 01 00 02 58 TDC=600s The time interval is represented by hexadecimal conversion to decimal.
If the payload=0100003C, it means set the END Node’s TDC to 0x00003C=60(S), 3C (HEX) = 60 (decimal),while type code is 01.
Payload: 01 00 00 1E TDC=30s Payload: 01 00 00 3C TDC=60s
Downlink Method
See use note for different serves Servers Note