Skip to Content
Last modified by BoYang Xie on 2025/07/24 16:47
From version 195.8
edited by BoYang Xie
on 2025/07/24 16:26
Change comment: There is no comment for this version
To version 195.10
edited by BoYang Xie
on 2025/07/24 16:28
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -451,7 +451,7 @@
451 451  
452 452  AT+SEND=1,014b69746368656e2d467269676531FFFFA84041000181D4A8**06**A4CB00,0,3
453 453  
454 -**LTS5 panel data format**:
454 +**Currently, there are two types of panel data formats in LTS5. One is the temperature and humidity type, and the other is the "switch" type. Here is the detailed introduction.**
455 455  
456 456  ~1. AT+SEND=1,**01**  **4b69746368656e2d467269676531FFFF  A84041000181D4A8  01  A4CB  BB0A  8E08  5C02**,0,3
457 457  
... ... @@ -481,6 +481,7 @@
481 481  
482 482  **5C02：**The humidity of the built-in sensor in LHT65N. 2 Bytes. Humidity: 0x025C/10=60.4%
483 483  
484 +
484 484  2. AT+SEND=1,**01**  **4b69746368656e2d467269676531FFFF**  **A84041000181D4A8**  **02  A4CB  00**,0,3
485 485  
486 486  Specific sections of the data share the same function.
... ... @@ -495,6 +495,7 @@
495 495  
496 496   If Panel Type is 0x06, **Status: 00~-~->OFF; 01~-~->Alarm.**
497 497  
499 +
498 498  == 5.3 Usage ==
499 499  
500 500  After burning the firmware into LTS5, you can use an LA66 equipped with peer-to-peer firmware to send data to LTS5 via AT commands.