Changes for page LT-22222-L -- LoRa I/O Controller User Manual
Last modified by Saxer Lin on 2025/04/15 17:24
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -413,6 +413,8 @@ 413 413 [[image:image-20220523181246-5.png]] 414 414 415 415 ((( 416 + 417 + 416 416 (% style="color:#4f81bd" %)**DIDORO**(%%) is a combination for RO1, RO2, DI3, DI2, DI1, DO3, DO2 and DO1. Totally 1bytes as below 417 417 ))) 418 418 ... ... @@ -426,6 +426,7 @@ 426 426 (% style="color:red" %)Note: DO3 is not valid for LT-22222-L. 427 427 ))) 428 428 431 + 429 429 ((( 430 430 **To use counting mode, please run:** 431 431 ))) ... ... @@ -558,8 +558,8 @@ 558 558 559 559 For example, if user has configured below commands: 560 560 561 -* **AT+MOD=1 ** **~-~->** The normal working mode 562 -* **AT+ADDMOD6=1** **~-~->** Enable trigger 564 +* **AT+MOD=1 ** **~-~->** The normal working mode 565 +* **AT+ADDMOD6=1** **~-~->** Enable trigger 563 563 564 564 LT will keep monitoring AV1/AV2/AC1/AC2 every 5 seconds; LT will send uplink packets in two cases: 565 565 ... ... @@ -566,8 +566,10 @@ 566 566 1. Periodically uplink (Base on TDC time). Payload is same as the normal MOD (MOD 1 for above command). This uplink uses LoRaWAN (% style="color:#4f81bd" %)**unconfirmed**(%%) data type 567 567 1. Trigger uplink when meet the trigger condition. LT will sent two packets in this case, the first uplink use payload specify in this mod (mod=6), the second packets use the normal mod payload(MOD=1 for above settings). Both Uplinks use LoRaWAN (% style="color:#4f81bd" %)**CONFIRMED data type.** 568 568 572 + 569 569 (% style="color:#037691" %)**AT Command to set Trigger Condition**: 570 570 575 + 571 571 (% style="color:#4f81bd" %)**Trigger base on voltage**: 572 572 573 573 Format: AT+AVLIM=<AV1_LIMIT_LOW>,< AV1_LIMIT_HIGH>,<AV2_LIMIT_LOW>,< AV2_LIMIT_HIGH> ... ... @@ -707,6 +707,8 @@ 707 707 708 708 * (% style="color:#4f81bd" %)**Sensor Related Commands**(%%): These commands are special designed for LT-22222-L. User can see these commands below: 709 709 715 + 716 + 710 710 === 3.4.1 Common Commands === 711 711 712 712 They should be available for each of Dragino Sensors, such as: change uplink interval, reset device. For firmware v1.5.4, user can find what common commands it supports: [[End Device AT Commands and Downlink Command>>doc:Main.End Device AT Commands and Downlink Command.WebHome]]