Changes for page LT-22222-L -- LoRa I/O Controller User Manual
Last modified by Saxer Lin on 2025/04/15 17:24
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -413,8 +413,6 @@ 413 413 [[image:image-20220523181246-5.png]] 414 414 415 415 ((( 416 - 417 - 418 418 (% style="color:#4f81bd" %)**DIDORO**(%%) is a combination for RO1, RO2, DI3, DI2, DI1, DO3, DO2 and DO1. Totally 1bytes as below 419 419 ))) 420 420 ... ... @@ -428,7 +428,6 @@ 428 428 (% style="color:red" %)Note: DO3 is not valid for LT-22222-L. 429 429 ))) 430 430 431 - 432 432 ((( 433 433 **To use counting mode, please run:** 434 434 ))) ... ... @@ -561,8 +561,8 @@ 561 561 562 562 For example, if user has configured below commands: 563 563 564 -* **AT+MOD=1 ** 565 -* **AT+ADDMOD6=1** **~-~->** 561 +* **AT+MOD=1 ** **~-~->** The normal working mode 562 +* **AT+ADDMOD6=1** **~-~->** Enable trigger 566 566 567 567 LT will keep monitoring AV1/AV2/AC1/AC2 every 5 seconds; LT will send uplink packets in two cases: 568 568 ... ... @@ -569,10 +569,8 @@ 569 569 1. Periodically uplink (Base on TDC time). Payload is same as the normal MOD (MOD 1 for above command). This uplink uses LoRaWAN (% style="color:#4f81bd" %)**unconfirmed**(%%) data type 570 570 1. Trigger uplink when meet the trigger condition. LT will sent two packets in this case, the first uplink use payload specify in this mod (mod=6), the second packets use the normal mod payload(MOD=1 for above settings). Both Uplinks use LoRaWAN (% style="color:#4f81bd" %)**CONFIRMED data type.** 571 571 572 - 573 573 (% style="color:#037691" %)**AT Command to set Trigger Condition**: 574 574 575 - 576 576 (% style="color:#4f81bd" %)**Trigger base on voltage**: 577 577 578 578 Format: AT+AVLIM=<AV1_LIMIT_LOW>,< AV1_LIMIT_HIGH>,<AV2_LIMIT_LOW>,< AV2_LIMIT_HIGH> ... ... @@ -712,8 +712,6 @@ 712 712 713 713 * (% style="color:#4f81bd" %)**Sensor Related Commands**(%%): These commands are special designed for LT-22222-L. User can see these commands below: 714 714 715 - 716 - 717 717 === 3.4.1 Common Commands === 718 718 719 719 They should be available for each of Dragino Sensors, such as: change uplink interval, reset device. For firmware v1.5.4, user can find what common commands it supports: [[End Device AT Commands and Downlink Command>>doc:Main.End Device AT Commands and Downlink Command.WebHome]]