Changes for page LT-22222-L -- LoRa I/O Controller User Manual
Last modified by Saxer Lin on 2025/04/15 17:24
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -554,8 +554,6 @@ 554 554 [[image:image-20220523182334-9.png]] 555 555 556 556 ((( 557 - 558 - 559 559 (% style="color:#4f81bd" %)**DIDORO**(%%) is a combination for RO1, RO2, DI3, DI2, DI1, DO3, DO2 and DO1. Totally 1bytes as below 560 560 ))) 561 561 ... ... @@ -570,8 +570,6 @@ 570 570 ))) 571 571 572 572 ((( 573 - 574 - 575 575 **To use this mode, please run:** 576 576 ))) 577 577 ... ... @@ -591,6 +591,8 @@ 591 591 592 592 ((( 593 593 Other AT Commands for counting are similar to [[MOD2 Counting Command>>||anchor="H3.3.2AT2BMOD3D22C28DoubleDICounting29"]]. 590 + 591 + 594 594 ))) 595 595 596 596 ... ... @@ -604,13 +604,11 @@ 604 604 * **AT+MOD=1 ** **~-~->** The normal working mode 605 605 * **AT+ADDMOD6=1** **~-~->** Enable trigger 606 606 607 - 608 608 LT will keep monitoring AV1/AV2/AC1/AC2 every 5 seconds; LT will send uplink packets in two cases: 609 609 610 610 1. Periodically uplink (Base on TDC time). Payload is same as the normal MOD (MOD 1 for above command). This uplink uses LoRaWAN (% style="color:#4f81bd" %)**unconfirmed**(%%) data type 611 611 1. Trigger uplink when meet the trigger condition. LT will sent two packets in this case, the first uplink use payload specify in this mod (mod=6), the second packets use the normal mod payload(MOD=1 for above settings). Both Uplinks use LoRaWAN (% style="color:#4f81bd" %)**CONFIRMED data type.** 612 612 613 - 614 614 **AT Command to set Trigger Condition**: 615 615 616 616 (% style="color:#4f81bd" %)**Trigger base on voltage**: ... ... @@ -662,12 +662,10 @@ 662 662 663 663 Yy4 yy4: AC2 or AV2 high limit. 664 664 665 - 666 666 **Example1**: AA 00 13 88 00 00 00 00 00 00 667 667 668 668 Same as AT+AVLIM=5000,0,0,0 (If AVI1 voltage lower than 5V , trigger uplink, 0 means ignore) 669 669 670 - 671 671 **Example2**: AA 02 01 00 672 672 673 673 Same as AT+ DTRI =1,0 (Enable DI1 trigger / disable DI2 trigger) ... ... @@ -710,7 +710,6 @@ 710 710 711 711 * Each bits shows which status has been trigger on this uplink. 712 712 713 - 714 714 **Example:** 715 715 716 716 00000111: Means both DI1 and DI2 trigger are enabled and this packet is trigger by DI1.