Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -666,7 +666,6 @@
666	666
667	667	Same as AT+ DTRI =1,0  (Enable DI1 trigger / disable DI2 trigger)
668	668
669		-
670	670	(% style="color:#4f81bd" %)**Trigger Settings Payload Explanation:**
671	671
672	672	MOD6 Payload : total 11 bytes payload
...	...	@@ -673,7 +673,6 @@
673	673
674	674	[[image:image-20220524085923-1.png]]
675	675
676		-
677	677	(% style="color:#4f81bd" %)**TRI FLAG1**(%%) is a combination to show if trigger is set for this part. Totally 1byte as below
678	678
679	679	[[image:image-20220524090106-2.png]]
...	...	@@ -680,7 +680,6 @@
680	680
681	681	* Each bits shows if the corresponding trigger has been configured.
682	682
683		-
684	684	**Example:**
685	685
686	686	10100000: Means the system has configure to use the trigger: AC1_LOW and AV2_LOW
...	...	@@ -692,7 +692,6 @@
692	692
693	693	* Each bits shows which status has been trigger on this uplink.
694	694
695		-
696	696	**Example:**
697	697
698	698	10000000: Means this packet is trigger by AC1_LOW. Means voltage too low.
...	...	@@ -744,7 +744,6 @@
744	744	* (% style="color:#4f81bd" %)**Sensor Related Commands**(%%): These commands are special designed for LT-22222-L.  User can see these commands below:
745	745
746	746
747		-
748	748	=== 3.4.1 Common Commands ===
749	749
750	750	They should be available for each of Dragino Sensors, such as: change uplink interval, reset device. For firmware v1.5.4, user can find what common commands it supports: [[End Device AT Commands and Downlink Command>>doc:Main.End Device AT Commands and Downlink Command.WebHome]]