Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -666,6 +666,7 @@
666	666
667	667	Same as AT+ DTRI =1,0  (Enable DI1 trigger / disable DI2 trigger)
668	668
	669	+
669	669	(% style="color:#4f81bd" %)**Trigger Settings Payload Explanation:**
670	670
671	671	MOD6 Payload : total 11 bytes payload
...	...	@@ -672,6 +672,7 @@
672	672
673	673	[[image:image-20220524085923-1.png]]
674	674
	676	+
675	675	(% style="color:#4f81bd" %)**TRI FLAG1**(%%) is a combination to show if trigger is set for this part. Totally 1byte as below
676	676
677	677	[[image:image-20220524090106-2.png]]
...	...	@@ -678,6 +678,7 @@
678	678
679	679	* Each bits shows if the corresponding trigger has been configured.
680	680
	683	+
681	681	**Example:**
682	682
683	683	10100000: Means the system has configure to use the trigger: AC1_LOW and AV2_LOW
...	...	@@ -689,6 +689,7 @@
689	689
690	690	* Each bits shows which status has been trigger on this uplink.
691	691
	695	+
692	692	**Example:**
693	693
694	694	10000000: Means this packet is trigger by AC1_LOW. Means voltage too low.
...	...	@@ -739,6 +739,8 @@
739	739
740	740	* (% style="color:#4f81bd" %)**Sensor Related Commands**(%%): These commands are special designed for LT-22222-L.  User can see these commands below:
741	741
	746	+
	747	+
742	742	=== 3.4.1 Common Commands ===
743	743
744	744	They should be available for each of Dragino Sensors, such as: change uplink interval, reset device. For firmware v1.5.4, user can find what common commands it supports: [[End Device AT Commands and Downlink Command>>doc:Main.End Device AT Commands and Downlink Command.WebHome]]
...	...	@@ -1105,7 +1105,7 @@
1105	1105
1106	1106
1107	1107
1108		-=== 3.4.2.14 Relay ~-~- Control Relay Output RO1/RO2 ===
	1114	+==== 3.4.2.14 Relay ~-~- Control Relay Output RO1/RO2 ====
1109	1109
1110	1110	* AT Command:
1111	1111