Summary

• Page properties (2 modified, 0 added, 0 removed)

Details

Page properties

Author

...	...	@@ -1,1 +1,1 @@
1		-XWiki.Xiaoling
	1	+XWiki.Bei

Content

...	...	@@ -15,6 +15,7 @@
15	15
16	16	= 1.Introduction =
17	17
	18	+
18	18	== 1.1 What is LT Series I/O Controller ==
19	19
20	20	(((
...	...	@@ -53,6 +53,7 @@
53	53
54	54	)))
55	55
	57	+
56	56	== 1.2  Specifications ==
57	57
58	58	(((
...	...	@@ -169,6 +169,7 @@
169	169	Packet engine up to 256 bytes with CRC.
170	170
171	171
	174	+
172	172
173	173	)))
174	174
...	...	@@ -184,7 +184,6 @@
184	184	* Counting
185	185
186	186
187		-
188	188	== 1.4  Applications ==
189	189
190	190
...	...	@@ -196,7 +196,6 @@
196	196	* Smart Factory
197	197
198	198
199		-
200	200	== 1.5 Hardware Variants ==
201	201
202	202
...	...	@@ -212,7 +212,6 @@
212	212	)))
213	213
214	214
215		-
216	216	= 2. Power ON Device =
217	217
218	218
...	...	@@ -294,6 +294,7 @@
294	294	[[image:1653298044601-602.png||height="405" width="709"]]
295	295
296	296
	297	+
297	297	== 3.3 Uplink Payload ==
298	298
299	299
...	...	@@ -307,7 +307,6 @@
307	307	* (% style="color:blue" %)**ADDMOD6**(%%): Trigger Mode, Optional, used together with MOD1 ~~ MOD5
308	308
309	309
310		-
311	311	=== 3.3.1 AT+MOD~=1, 2ACI+2AVI ===
312	312
313	313
...	...	@@ -365,7 +365,6 @@
365	365	** DO1 LED is off in both case
366	366
367	367
368		-
369	369	=== 3.3.2 AT+MOD~=2, (Double DI Counting) ===
370	370
371	371
...	...	@@ -654,6 +654,7 @@
654	654	AT+ DTRI =1,0   (Enable DI1 trigger / disable DI2 trigger)
655	655
656	656
	656	+
657	657	(% style="color:#037691" %)**Downlink Command to set Trigger Condition:**
658	658
659	659	Type Code: 0xAA. Downlink command same as AT Command **AT+AVLIM, AT+ACLIM**
...	...	@@ -714,6 +714,7 @@
714	714	10000000: Means this packet is trigger by AC1_LOW. Means voltage too low.
715	715
716	716
	717	+
717	717	(% style="color:#4f81bd" %)**TRI_DI FLAG+STA **(%%)is a combination to show which condition is trigger. Totally 1byte as below
718	718
719	719	[[image:image-20220524090456-4.png]]
...	...	@@ -727,6 +727,7 @@
727	727	00000101: Means both DI1 and DI2 trigger are enabled.
728	728
729	729
	731	+
730	730	(% style="color:#4f81bd" %)**Enable/Disable MOD6 **(%%): 0x01: MOD6 is enable. 0x00: MOD6 is disable.
731	731
732	732	Downlink command to poll MOD6 status:
...	...	@@ -763,7 +763,6 @@
763	763	* (% style="color:blue" %)**Sensor Related Commands**(%%): These commands are special designed for LT-22222-L.  User can see these commands below:
764	764
765	765
766		-
767	767	=== 3.4.1 Common Commands ===
768	768
769	769
...	...	@@ -849,6 +849,7 @@
849	849
850	850
851	851
	853	+
852	852	==== 3.4.2.5 Poll trigger settings ====
853	853
854	854
...	...	@@ -1063,9 +1063,8 @@
1063	1063
1064	1064	Latching time. Unit: ms
1065	1065
	1068	+Note:
1066	1066
1067		-(% style="color:red" %)**Note: **
1068		-
1069	1069	Since Firmware v1.6.0, the latch time support 4 bytes and 2 bytes
1070	1070
1071	1071	Before Firmwre v1.6.0 the latch time only suport 2 bytes.
...	...	@@ -1094,7 +1094,7 @@
1094	1094
1095	1095
1096	1096
1097		-==== 3.4.2. 14 Relay ~-~- Control Relay Output RO1/RO2 ====
	1098	+==== 3.4.2.14 Relay ~-~- Control Relay Output RO1/RO2 ====
1098	1098
1099	1099
1100	1100	* (% style="color:#037691" %)**AT Command:**
...	...	@@ -1123,6 +1123,7 @@
1123	1123
1124	1124
1125	1125
	1127	+
1126	1126	==== 3.4.2.15 Relay ~-~- Control Relay Output RO1/RO2 with time control ====
1127	1127
1128	1128
...	...	@@ -1154,9 +1154,8 @@
1154	1154
1155	1155	(% style="color:#4f81bd" %)**Fourth/Fifth/Sixth/Seventh Bytes(cc)**(%%): Latching time. Unit: ms
1156	1156
	1159	+Note:
1157	1157
1158		-(% style="color:red" %)**Note:**
1159		-
1160	1160	Since Firmware v1.6.0, the latch time support 4 bytes and 2 bytes
1161	1161
1162	1162	Before Firmwre v1.6.0 the latch time only suport 2 bytes.
...	...	@@ -1167,7 +1167,7 @@
1167	1167
1168	1168	**Example payload:**
1169	1169
1170		-**~1. 05 01 11 07 D0**
	1171	+**~1. 05 01 11 07 D**
1171	1171
1172	1172	Relay1 and Relay 2 will be set to NC , last 2 seconds, then change back to original state.
1173	1173
...	...	@@ -1302,6 +1302,7 @@
1302	1302
1303	1303
1304	1304
	1306	+
1305	1305	==== 3.4.2.24 When the limit bytes are exceeded, upload in batches ====
1306	1306
1307	1307
...	...	@@ -1318,6 +1318,7 @@
1318	1318
1319	1319
1320	1320
	1323	+
1321	1321	==== 3.4.2.25 Copy downlink to uplink ====
1322	1322
1323	1323
...	...	@@ -1471,6 +1471,8 @@
1471	1471
1472	1472	(((
1473	1473
	1477	+
	1478	+
1474	1474	)))
1475	1475
1476	1476	(((
...	...	@@ -1502,6 +1502,8 @@
1502	1502
1503	1503	(((
1504	1504
	1510	+
	1511	+
1505	1505	)))
1506	1506
1507	1507	(((
...	...	@@ -1594,6 +1594,7 @@
1594	1594	[[image:image-20220524100748-11.png]]
1595	1595
1596	1596
	1604	+
1597	1597	= 4. Use AT Command =
1598	1598
1599	1599	== 4.1 Access AT Command ==
...	...	@@ -1937,6 +1937,7 @@
1937	1937
1938	1938	)))
1939	1939
	1948	+
1940	1940	=== 4.2.3 Change to Class A ===
1941	1941
1942	1942
...	...	@@ -2170,7 +2170,6 @@
2170	2170	* (% style="color:red" %)**CN779**(%%):  LT with frequency bands CN779
2171	2171
2172	2172
2173		-
2174	2174	= 8. Packing Info =
2175	2175
2176	2176
...	...	@@ -2189,7 +2189,6 @@
2189	2189	* Weight / pcs : 170g
2190	2190
2191	2191
2192		-
2193	2193	= 9. Support =
2194	2194
2195	2195
...	...	@@ -2209,5 +2209,3 @@
2209	2209	* LT-22222-L: [[http:~~/~~/www.dragino.com/products/lora-lorawan-end-node/item/156-lt-22222-l.html>>url:http://www.dragino.com/products/lora-lorawan-end-node/item/156-lt-22222-l.html]]
2210	2210	* [[Datasheet, Document Base>>https://www.dropbox.com/sh/gxxmgks42tqfr3a/AACEdsj_mqzeoTOXARRlwYZ2a?dl=0]]
2211	2211	* [[Hardware Source>>url:https://github.com/dragino/Lora/tree/master/LT/LT-33222-L/v1.0]]
2212		-
2213		-