Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -64,7 +64,7 @@
64	64	)))
65	65
66	66	* (((
67		-STM32L072CZT6 MCU
	67	+STM32L072xxxx MCU
68	68	)))
69	69	* (((
70	70	SX1276/78 Wireless Chip
...	...	@@ -186,7 +186,6 @@
186	186	* Firmware upgradable via program port
187	187	* Counting
188	188
189		-
190	190	== 1.4  Applications ==
191	191
192	192
...	...	@@ -197,7 +197,6 @@
197	197	* Smart Cities
198	198	* Smart Factory
199	199
200		-
201	201	== 1.5 Hardware Variants ==
202	202
203	203
...	...	@@ -212,7 +212,6 @@
212	212	* 1 x Counting Port
213	213	)))
214	214
215		-
216	216	= 2. Power ON Device =
217	217
218	218
...	...	@@ -310,7 +310,6 @@
310	310	* (% style="color:blue" %)**MOD5**(%%): Single DI Counting + 2 x AVI + 1 x ACI + DO + RO
311	311	* (% style="color:blue" %)**ADDMOD6**(%%): Trigger Mode, Optional, used together with MOD1 ~~ MOD5
312	312
313		-
314	314	=== 3.3.1 AT+MOD~=1, 2ACI+2AVI ===
315	315
316	316
...	...	@@ -367,7 +367,6 @@
367	367	** DO1 is high in case there is load between DO1 and V+.
368	368	** DO1 LED is off in both case
369	369
370		-
371	371	=== 3.3.2 AT+MOD~=2, (Double DI Counting) ===
372	372
373	373
...	...	@@ -773,7 +773,6 @@
773	773
774	774	* (% style="color:blue" %)**Sensor Related Commands**(%%): These commands are special designed for LT-22222-L.  User can see these commands below:
775	775
776		-
777	777	=== 3.4.1 Common Commands ===
778	778
779	779
...	...	@@ -1076,6 +1076,13 @@
1076	1076
1077	1077	Latching time. Unit: ms
1078	1078
	1073	+Note:
	1074	+
	1075	+ Since Firmware v1.6.0, the latch time support 4 bytes and 2 bytes
	1076	+
	1077	+ Before Firmwre v1.6.0 the latch time only suport 2 bytes.
	1078	+
	1079	+
1079	1079	(% style="color:red" %)**Device will upload a packet if downlink code executes successfully.**
1080	1080
1081	1081
...	...	@@ -1160,6 +1160,13 @@
1160	1160
1161	1161	(% style="color:#4f81bd" %)**Fourth/Fifth/Sixth/Seventh Bytes(cc)**(%%): Latching time. Unit: ms
1162	1162
	1164	+Note:
	1165	+
	1166	+ Since Firmware v1.6.0, the latch time support 4 bytes and 2 bytes
	1167	+
	1168	+ Before Firmwre v1.6.0 the latch time only suport 2 bytes.
	1169	+
	1170	+
1163	1163	(% style="color:red" %)**Device will upload a packet if downlink code executes successfully.**
1164	1164
1165	1165
...	...	@@ -1251,14 +1251,14 @@
1251	1251
1252	1252
1253	1253
1254		-==== 3.4.2.20 Reset save DR DO state ====
	1262	+==== 3.4.2.20 Reset save RO DO state ====
1255	1255
1256	1256
1257	1257	* (% style="color:#037691" %)**AT Command:**
1258	1258
1259		-(% style="color:blue" %)**AT+RODORET=1    **(%%)~/~/ RODO will close when the device joining the network. (default)
	1267	+(% style="color:blue" %)**AT+RODORESET=1    **(%%)~/~/ RODO will close when the device joining the network. (default)
1260	1260
1261		-(% style="color:blue" %)**AT+RODORET=0    **(%%)~/~/ After the device is reset, the previously saved RODO state (only MOD2 to MOD5) is read, and its state is not changed when it is reconnected to the network.
	1269	+(% style="color:blue" %)**AT+RODORESET=0    **(%%)~/~/ After the device is reset, the previously saved RODO state (only MOD2 to MOD5) is read, and its state is not changed when it is reconnected to the network.
1262	1262
1263	1263
1264	1264	* (% style="color:#037691" %)**Downlink Payload (prefix 0xAD):**
...	...	@@ -1588,7 +1588,7 @@
1588	1588
1589	1589
1590	1590	(((
1591		-The LT serial controller has two relay interfaces; each interface uses two pins of the screw terminal. User can connect other device’s Power Line to in serial of RO1_1 and RO_2. Such as below:
	1599	+The LT serial controller has two relay interfaces; each interface uses two pins of the screw terminal. User can connect other device's Power Line to in serial of RO1_1 and RO_2. Such as below:
1592	1592
1593	1593	**Note**: RO pins go to Open(NO) when device is power off.
1594	1594	)))
...	...	@@ -2104,7 +2104,7 @@
2104	2104	== 5.5 Can i use point to point communication for LT-22222-L? ==
2105	2105
2106	2106
2107		-Yes, please refer [[Point to Point Communication>>doc:Main. Point to Point Communication of LT-22222-L.WebHome]]  ，this is [[firmware>>https://www.dropbox.com/sh/g99v0fxcltn9r1y/AADKXQ2v5ZT-S3sxdmbvE7UAa/LT-22222-L/image?dl=0&subfolder_nav_tracking=1]].
	2115	+Yes, please refer [[Point to Point Communication>>doc:Main. Point to Point Communication of LT-22222-L.WebHome]]  ，this is [[firmware>>https://github.com/dragino/LT-22222-L/releases]].
2108	2108
2109	2109
2110	2110
...	...	@@ -2202,7 +2202,6 @@
2202	2202	* (% style="color:red" %)**IN865**(%%):  LT with frequency bands IN865
2203	2203	* (% style="color:red" %)**CN779**(%%):  LT with frequency bands CN779
2204	2204
2205		-
2206	2206	= 8. Packing Info =
2207	2207
2208	2208
...	...	@@ -2220,7 +2220,6 @@
2220	2220	* Package Size / pcs : 14.5 x 8 x 5 cm
2221	2221	* Weight / pcs : 170g
2222	2222
2223		-
2224	2224	= 9. Support =
2225	2225
2226	2226