Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -86,9 +86,6 @@
86	86	* IP66 Waterproof Enclosure
87	87	* 4000mAh or 8500mAh Battery for long term use
88	88
89		-
90		-
91		-
92	92	== 1.3  Specification ==
93	93
94	94	=== 1.3.1  Rated environmental conditions ===
...	...	@@ -132,9 +132,6 @@
132	132	* Sewer
133	133	* Bottom water level monitoring
134	134
135		-
136		-
137		-
138	138	== 1.6  Pin mapping and power on ==
139	139
140	140
...	...	@@ -290,8 +290,6 @@
290	290	* If the sensor value lower than 0x0118 (280mm), the sensor value will be invalid. Since v1.1.4, all value lower than 280mm will be set to 0x0014(20mm) which means the value is invalid.
291	291
292	292
293		-
294		-
295	295	=== 2.3.3  Interrupt Pin ===
296	296
297	297	This data field shows if this packet is generated by interrupt or not. [[Click here>>||anchor="H3.3A0SetInterruptMode"]] for the hardware and software set up.
...	...	@@ -869,7 +869,6 @@
869	869
870	870
871	871
872		-
873	873	== 2.8  ​Firmware Change Log ==
874	874
875	875
...	...	@@ -1060,12 +1060,11 @@
1060	1060	* Example 1: Downlink Payload: 0100001E ~/~/ Set Transmit Interval (TDC) = 30 seconds
1061	1061	* Example 2: Downlink Payload: 0100003C ~/~/ Set Transmit Interval (TDC) = 60 seconds
1062	1062	)))
1063		-)))
1064	1064
1065	1065
	1056	+
	1057	+)))
1066	1066
1067		-
1068		-
1069	1069	== 3.3  Set Interrupt Mode ==
1070	1070
1071	1071	Feature, Set Interrupt mode for GPIO_EXIT.
...	...	@@ -1086,9 +1086,6 @@
1086	1086	* Example 1: Downlink Payload: 06000000 ~/~/ Turn off interrupt mode
1087	1087	* Example 2: Downlink Payload: 06000003 ~/~/ Set the interrupt mode to rising edge trigger
1088	1088
1089		-
1090		-
1091		-
1092	1092	= 4.  FAQ =
1093	1093
1094	1094	== 4.1  What is the frequency plan for LDDS75? ==