<
From version < 150.55 >
edited by Xiaoling
on 2022/06/11 09:22
To version < 150.57 >
edited by Xiaoling
on 2022/06/11 09:23
>
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1044,7 +1044,9 @@
1044 1044  (((
1045 1045  Format: Command Code (0x01) followed by 3 bytes time value.
1046 1046  
1047 +(((
1047 1047  If the downlink payload=0100003C, it means set the END Node’s Transmit Interval to 0x00003C=60(S), while type code is 01.
1049 +)))
1048 1048  
1049 1049  * Example 1: Downlink Payload: 0100001E ~/~/ Set Transmit Interval (TDC) = 30 seconds
1050 1050  * Example 2: Downlink Payload: 0100003C ~/~/ Set Transmit Interval (TDC) = 60 seconds
... ... @@ -1067,7 +1067,9 @@
1067 1067  
1068 1068  Format: Command Code (0x06) followed by 3 bytes.
1069 1069  
1072 +(((
1070 1070  This means that the interrupt mode of the end node is set to 0x000003=3 (rising edge trigger), and the type code is 06.
1074 +)))
1071 1071  
1072 1072  * Example 1: Downlink Payload: 06000000 ~/~/ Turn off interrupt mode
1073 1073  * Example 2: Downlink Payload: 06000003 ~/~/ Set the interrupt mode to rising edge trigger
Copyright ©2010-2024 Dragino Technology Co., LTD. All rights reserved
Dragino Wiki v2.0