Skip to Content
Last modified by Mengting Qiu on 2025/06/10 18:53
From version 32.10
edited by Xiaoling
on 2022/06/24 14:59
Change comment: There is no comment for this version
To version 32.9
edited by Xiaoling
on 2022/06/24 14:57
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -382,7 +382,6 @@
382 382  These commands only valid for WSC1-L, as below:
383 383  
384 384  
385 -
386 386  == 3.1 Set Transmit Interval Time ==
387 387  
388 388  Feature: Change LoRaWAN End Node Transmit Interval.
... ... @@ -402,9 +402,6 @@
402 402  * Example 2: Downlink Payload: 0100003C ~/~/ Set Transmit Interval (TDC) = 60 seconds
403 403  
404 404  
405 -
406 -
407 -
408 408  == 3.2 Set Emergency Mode ==
409 409  
410 410  Feature: In emergency mode, WSC1-L will uplink data every 1 minute.
... ... @@ -420,9 +420,6 @@
420 420  * 0xE100     Same as: AT+ALARMMOD=0
421 421  
422 422  
423 -
424 -
425 -
426 426  == 3.3 Add or Delete RS485 Sensor ==
427 427  
428 428  Feature: User can add or delete 3^^rd^^ party sensor as long they are RS485/Modbus interface,baud rate support 9600.Maximum can add 4 sensors.
... ... @@ -492,9 +492,6 @@
492 492  * 0xE5FF  
493 493  
494 494  
495 -
496 -
497 -
498 498  == 3.4 RS485 Test Command ==
499 499  
500 500  (% style="color:#037691" %)**AT Command:**
... ... @@ -517,9 +517,6 @@
517 517  * 0xE20103000001840A     Same as: AT+RSWRITE=0103000001840A
518 518  
519 519  
520 -
521 -
522 -
523 523  == 3.5 RS485 response timeout ==
524 524  
525 525  Feature: Set or get extended time to receive 485 sensor data.
... ... @@ -544,9 +544,6 @@
544 544  * Example 2: Downlink Payload: E000000A ~/~/ Set Transmit Interval (DTR) = 10 seconds
545 545  
546 546  
547 -
548 -
549 -
550 550  == 3.6 Set Sensor Type ==
551 551  
552 552  Feature: Set sensor in used. If there are 6 sensors, user can set to only send 5 sensors values.