UART Access for LoRa ST v4 base model

Version 15.2 by Xiaoling on 2022/12/28 10:58
Warning
For security reasons, the document is displayed in restricted mode as it is not the current version. There may be differences and errors due to this.

Table of Contents:

1. LoRaST v4 base Hardware

Below hardware use LoRaST v4 module. They module support UART Access for AT Command and Firmware Upgrade.
Failed to execute the [velocity] macro. Cause: [The execution of the [velocity] script macro is not allowed in [xwiki:Main.UART Access for LoRa ST v4 base model.WebHome]. Check the rights of its last author or the parameters if it's rendered from another script.]. Click on this message for details.

ModelMother BoardUART for AT CommandsUART for Upgrade Firmware

PS-LB 

SIBInstructionInstruction

2. UART for AT Commands

2.1 Generate software set up for AT Commands via UART

  1. Use a general serial tool.
  2. Connect PC to device's UART interface
  3. Set up serial tool with : BaudRate: 9600, databit:8, No parity, No flow control.

image-20221224170218-1.png

2.2 UART Connection for SIB mother board

image-20221224171304-3.png

3. UART for Firmware Upgrade

3.1 General Instruction for UART update firmware

LoRaSTv4 Base hardware support UART update firmware. the UART connection is the same as AT Command connection, with the need for two extra action. See below for the steps:

     Step1: Set BOOT Switch to PROG mode. PROG mode is for update firmware specially.

     Step2: Press Reset button, the module will then boot into program mode. 

     Step3: Use TremoProgrammer to update the firmware to LoRaST v4.

     Step4: Set BOOT Switch to FLASH position. Press Reset button again and module will run the new software.

Below is the method for how to update via TremoProgrammer:

1.  Software download link:  https://www.dropbox.com/sh/j0qyc7a9ejit7jk/AACtx2tK4gEv6YFXMIVUM4dLa?dl=0

2.  Run TremoProgrammer.

3.  Choose software and set the address to 0x0800D000

4. Rember to set BOOT Switch to FLASH after update

image-20221224174341-4.png

3.2 UART Connection for SIB mother board for Program.

Below shows the SIB board UART connection, reset button and BOOT Switch (Program Jumper) position. They can be used for firmware upgrade reference.

image-20221224174605-6.png