Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -65,15 +65,14 @@
65	65	Run AT Command to make LoRaWAN End Node to work in Single frequency & ABP mode. Below is the AT commands:
66	66
67	67	* AT+FDR Reset Parameters to Factory Default, Keys Reserve
68		-* AT+NJM=0 Set to ABP mode ~-~-> This must be 0
	68	+* AT+NJM=0 Set to ABP mode  ~-~-> This must be 0
69	69	* AT+ADR=0 Set the Adaptive Data Rate Off ~-~-> This must be 0
70		-* AT+DR=5  Set Data Rate (Set AT+DR=3 for 915 band)  ~-~-> Can use other DR but need to match the gateway setting.
71		-* AT+CHS=868400000  Set transmit frequency to 868.4Mhz  ~-~-> Can use other Frequency but need to match the gateway setting.
72		-* AT+DADDR=26 01 1A F1  Set Device Address to 26 01 1A F1 ~-~-> Make sure this match Server setting
	70	+* AT+DR=5  Set Data Rate (Set AT+DR=3 for 915 band)  ~-~-> Can use other DR but need to match the gateway setting.
	71	+* AT+CHS=868400000  Set transmit frequency to 868.4Mhz  ~-~->  Can use other Frequency but need to match the gateway setting.
	72	+* AT+DADDR=26 01 1A F1  Set Device Address to 26 01 1A F1 ~-~->  Make sure this match Server setting
73	73	* ATZ Reset MCU
74	74
75	75
76		-
77	77	As shown in below:
78	78
79	79	[[image:image-20220601111608-1.png]]
...	...	@@ -90,7 +90,6 @@
90	90	* SF: 7 ~-~-> Must match the End Node DR settings. More about this please check [[LoRaWAN Region setting>>url:https://lora-alliance.org/sites/default/files/2018-07/lorawan_regional_parameters_v1.0.3reva_0.pdf]]. The End Node us EU868 frequency band, the DR5 equal to SF7/ Bandwidth 125Khz, so we need to set SF=7 here (ABove document Page 16).
91	91
92	92
93		-
94	94	[[image:image-20220527164647-3.png]]
95	95
96	96	Configure Gateway