Summary

• Page properties (1 modified, 0 added, 0 removed)
• Attachments (0 modified, 1 added, 0 removed)
  • image-20220601111608-1.png

Details

Page properties

Content

...	...	@@ -56,6 +56,7 @@
56	56
57	57	== 2.2 Step2: Configure End Node radio parameters ==
58	58
	59	+
59	59	Run AT Command to make LoRaWAN End Node to work in Single frequency & ABP mode. Below is the AT commands:
60	60
61	61	* AT+FDR Reset Parameters to Factory Default, Keys Reserve
...	...	@@ -66,9 +66,10 @@
66	66	* AT+DADDR=26 01 1A F1 Set Device Address to 26 01 1A F1 ~-~-> Make sure this match Server setting
67	67	* ATZ Reset MCU
68	68
	70	+
69	69	As shown in below:
70	70
71		-[[image:image-20220527164615-2.png]]
	73	+[[image:image-20220601111608-1.png]]
72	72
73	73	Configure Device
74	74
...	...	@@ -75,6 +75,7 @@
75	75
76	76	== 2.3 Step3: Configure Gateway ==
77	77
	80	+
78	78	Configure gateway so it can receive the packet sent from End Node:
79	79
80	80	* RX frequency: 868400000 ~-~-> Must same as the End Node AT+CHS settings.

image-20220601111608-1.png

Author

...	...	@@ -1,0 +1,1 @@
	1	+XWiki.Xiaoling

Size

...	...	@@ -1,0 +1,1 @@
	1	+26.8 KB

Content