Contents:
- 1. Introduction
- 2. Semtech UDP
- 3. Semtech Basic Station
- 4. Gateway and device sending and receiving situation
- 4. Downlink
- 5. Create LHT65 node
1. Introduction
Here list some notice when connect to Senet
2. Semtech UDP
Here is how to create a gateway on senet. Here are the steps to create a gateway.
Location address
Gateway type
Gateway information
Installation information
note:After the gateway is created, the gateway EUI has not been obtained. You need to wait for the server to allocate the gateway EUI. At this time, you may need to wait several hour.
When you get the gateway EUI, you can see it in the mail or server.
Then enter the LORAWAN configuration, fill in the gateway ID and server address.
LORAWAN Configuration
Server successfully connected to gateway.
3. Semtech Basic Station
3.1 Register Gateway
4. Gateway and device sending and receiving situation
Detailed status of the device sending and receiving packets
status
Channel frequency
channel
4. Downlink
Downlink payload
Downlink
5. Create LHT65 node
lht65
lht65
lht65
Payload uploaded by LHT65.
lht65