Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -396,7 +396,7 @@
396	396
397	397	To get the AIS current image on the PC, you can issue commands through TTN or connect AIS to your PC with TTL to send commands through the serial port to obtain relevant data packets.
398	398
399		-=== 3.2.1 The image packets are obtained by TTN ===
	399	+=== 3.2.1 The image date are obtained by TTN ===
400	400
401	401	Make sure that node ACK is on: AT+PNACKMD=1 or 34 01
402	402
...	...	@@ -434,17 +434,14 @@
434	434
435	435	[[image:image-20240430162820-5.png||height="218" width="532"]]
436	436
437		-==== ====
438		-
439	439	==== 3.2.1.2 BAT- Battery information ====
440	440
441	441	These two bytes of BAT include the battery state and the actual voltage.
442	442
	441	+[[image:image-20240430163600-8.png||height="50" width="1141"]]
443	443
444	444	**Ex**：0X0BBE= 3006 mv
445	445
446		-==== ====
447		-
448	448	==== 3.2.1.3 total_packages ====
449	449
450	450	This byte represents the total number of packets for the image fetched this time.
...	...	@@ -451,8 +451,6 @@
451	451
452	452	[[image:image-20240430163626-9.png||height="47" width="1116"]]
453	453
454		-==== ====
455		-
456	456	==== 3.2.1.4 subcontracting_count ====
457	457
458	458	This byte represents the data number of the image packet retrieved
...	...	@@ -499,7 +499,7 @@
499	499
500	500	[[image:1714467134950-189.png]]
501	501
502		-=== 3.2.2 Get the current image packet by connecting the AUC USB TTL adapters for AIS Sensors to the AIS Sensor. ===
	497	+=== 3.2.2 The image date are obtained by serial port ===
503	503
504	504	Select the corresponding baud rate and serial port number through the serial port tool, select HEX display and HEX send, and continuously receive data from the AIS Sensor
505	505
...	...	@@ -508,5 +508,3 @@
508	508
509	509
510	510	Then follow the instructions in 3.2.1.6 to get the image from AIS Sensor.
511		-
512		-