LPS8v2 User Manual

The HP0C is an open-source LoRaWAN Gateway. It lets you bridge LoRa wireless network to an IP network via WiFi, Ethernet. The LoRa wireless allows users to send data and reach extremely long ranges at low data-rates.

HP0C has pre-configured standard LoRaWAN frequency bands to use for different countries. Users can also customize the frequency bands to use in their own LoRaWAN network.

1.2 Specifications

Hardware System:

         Linux Part:

• Dragino H3-Core Linux Module

• Quad-core Cortex-A7 1.2Ghz

• RAM: 512MB

• eMMC: 4GB

Interface:

• 10M/100M RJ45 Ports x 1
• LoRaWAN Wireless

Operating Condition:

• Work Temperature: -20 ~ 65°C
• Storage Temperature: -20 ~ 65°C
• Power Input: 5V 2A, DC

1.3 Features

• Open Source Debian system
• Managed by Web GUI, SSH via WAN or WiFi
• Remote access with Reverse-SSH
• Emulates 49x LoRa demodulators
• LoRaWAN Gateway
• 10 programmable parallel demodulation paths
• Pre-configure to support different LoRaWAN regional settings.
• Allow customizing LoRaWAN regional parameters.
• Support Local decode ABP end node info and transfer to MQTT server
• Support different level login.

World Widely. Include US and EU

1.4 Block Diagram

2. Connect LPS8v2 Web UI

Connect the LPS8v2 Ethernet port to your router and LPS8v2 will obtain an IP address from your router. In the router’s management portal, you should be able to find what IP address the router has assigned to the LPS8v2.

If you get the IP address from the router, like: 10.130.2.123, you can use this IP address to connect the WEB UI or SSH access of LPS8v2.

10. Supports

10. Order Info

LPS8v2-XXX

XXX: Frequency Band

• AS923: LoRaWAN AS923 band
• AU915: LoRaWAN AU915 band
• EU868: LoRaWAN EU868 band
• KR920: LoRaWAN KR920 band
• US915: LoRaWAN US915 band
• IN865: LoRaWAN IN865 band

11. Manufacturer Info

Shenzhen Dragino Technology Development co. LTD

Room 202, Block B, BCT Incubation Bases (BaoChengTai),  No.8 CaiYunRoad

LongCheng Street, LongGang District ; Shenzhen 518116,China

12. FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.