Contents:
1. Introduction
The Dragino LoRaWAN gateway can commuicate with LORIOT LoRaWAN Network Server:
Below list the support products and Requirements:
Firmware version since :LG02_LG08--build-v5.4.1590459021-20200526-1012
2. Gateway Setup Instruction
2.1 Step 1: Get Gateway ETH0 MAC Address
Dragino LoRaWAn gateway use ETH0 MAC address to generate Gateway ID to communicate with LORIOT, User can get the ETH0 MAC address from SSH access and run ifconfig command.
Get ETH0 MAC address
Note: To make set up more friendly, the ETH0 will show on the LORIOT page in a new firmware version.
2.2 Step 2: Choose LORIOT service
Choose to use LORIOT as LoRaWAN service provider
Install and choose the LORIOT server to be used
2.3 Step 3: Checking Connection Status
Click to Home page and check the connection status
2.4 Step 4: Setup Account in LORIOT
Login LORIOT and create account
Log in LORIOT portal
Choose to use the server same as the gateway setting
Choose server
Create a New Network
Create a New Network
Create a New Network
2.5 Step 5: Register the gateway
Register the Gateway in LORIOT
Choose LG308 as gateway model
Choose LG308 as gateway model
Input Gateway ETH0 address
Choose SX1301 Reference and use SPI protocol
Choose the right Frequency Band and input location
Set up regional settings.
2.6 Step 6: Check Connection
LORIOT will show disconnect if Gateway doesn't connect
LORIOT will show connect if Gateway connect to LORIOT ok.
Status: Connected
2.7 Debug If there is connection issue
User can check if loriot is running by checking the web ui
Status: Connected
If user want to see more log, he can run below commands in Linux and see the full log:
ps | grep "loriot_dragino" | grep -v grep | awk '{print $1}' | xargs kill -s 9
/usr/bin/loriot_dragino_lg308_spi -f -s eu1.loriot.io
Above two commands will first kill the loriot process and run it again to get more output.
Get more debug info