Changes for page LHT52 - LoRaWAN Temperature & Humidity Sensor User Manual
Last modified by Mengting Qiu on 2024/04/30 14:27
Change comment:
There is no comment for this version
Summary
-
Page properties (2 modified, 0 added, 0 removed)
Details
- Page properties
-
- Author
-
... ... @@ -1,1 +1,1 @@ 1 -XWiki. Edwin1 +XWiki.Xiaoling - Content
-
... ... @@ -214,7 +214,6 @@ 214 214 ((( 215 215 [[Built-in>>||anchor="H2.4.4Built-inHumidity"]] 216 216 ))) 217 - 218 218 ((( 219 219 [[Humidity>>||anchor="H2.4.4Built-inHumidity"]] 220 220 ))) ... ... @@ -338,7 +338,7 @@ 338 338 Status & Ext 339 339 )))|(% style="width:64px" %)((( 340 340 ((( 341 -[[Unix Time Stamp>>||anchor="H2.6.2UnixTimeStamp"]] 340 +[[Unix Time Stamp>>||anchor="H2.6.2Unix TimeStamp"]] 342 342 ))) 343 343 ))) 344 344 ... ... @@ -559,7 +559,7 @@ 559 559 )))|(% style="width:48px" %)((( 560 560 ((( 561 561 ((( 562 -[[Unix Time Stamp>>||anchor="H2.6. 2UnixTimeStamp"]]561 +[[Unix Time Stamp>>||anchor="H2.6.1UnixTimeStamp"]] 563 563 ))) 564 564 ))) 565 565 ... ... @@ -674,7 +674,7 @@ 674 674 675 675 == 2.7 Alarm Mode == 676 676 677 -When device is in Alarm mode, it will check the built-in sensor temperature in a short interval. If the temperature exceeds the pre-configure range, it will send an uplink immediately. 676 +Alarm mode feature is added since firmware v1.5. When device is in Alarm mode, it will check the built-in sensor temperature in a short interval. If the temperature exceeds the pre-configure range, it will send an uplink immediately. 678 678 679 679 ((( 680 680 (% style="color:red" %)Note: Alarm mode will increase a little big the power consumption, we recommend extending the normal reading time when enabling this feature.