Changes for page LHT52 - LoRaWAN Temperature & Humidity Sensor User Manual
Last modified by Mengting Qiu on 2024/04/30 14:27
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -214,6 +214,7 @@ 214 214 ((( 215 215 [[Built-in>>||anchor="H2.4.4Built-inHumidity"]] 216 216 ))) 217 + 217 217 ((( 218 218 [[Humidity>>||anchor="H2.4.4Built-inHumidity"]] 219 219 ))) ... ... @@ -553,12 +553,12 @@ 553 553 ))) 554 554 )))|(% style="width:86px" %)((( 555 555 ((( 556 - [[Poll message flag & Ext>>||anchor="H2.6.4DatalogUplinkpayload"]]557 +Poll message flag & Ext 557 557 ))) 558 558 )))|(% style="width:48px" %)((( 559 559 ((( 560 560 ((( 561 -[[Unix Time Stamp>>||anchor="H2.6. 1UnixTimeStamp"]]562 +[[Unix Time Stamp>>||anchor="H2.6.2UnixTimeStamp"]] 562 562 ))) 563 563 ))) 564 564 ... ... @@ -673,7 +673,7 @@ 673 673 674 674 == 2.7 Alarm Mode == 675 675 676 - Alarm mode feature is added since firmware v1.5.When device is in Alarm mode, it will check the built-in sensor temperature in a short interval. If the temperature exceeds the pre-configure range, it will send an uplink immediately.677 +When device is in Alarm mode, it will check the built-in sensor temperature in a short interval. If the temperature exceeds the pre-configure range, it will send an uplink immediately. 677 677 678 678 ((( 679 679 (% style="color:red" %)Note: Alarm mode will increase a little big the power consumption, we recommend extending the normal reading time when enabling this feature.