Skip to Content
Last modified by Karry Zhuang on 2024/09/20 17:17
From version 30.1
edited by Karry Zhuang
on 2024/04/23 15:19
Change comment: Uploaded new attachment "layout.bin", version {1}
To version 34.2
edited by Karry Zhuang
on 2024/04/24 16:23
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -6,10 +6,12 @@
6 6  
7 7  = 2. Hardware Connection =
8 8  
9 -The data cable should be connected to the AIS (note: there is no camera on this side), while the computer should be connected on the other side.
9 +The AI Sensors and UART are connected and then connected to the PC.
10 10  
11 -[[image:image-20240419145552-1.jpeg||height="399" width="476"]] [[image:image-20240419145552-2.jpeg||height="395" width="395"]]
11 +[[image:image-20240424145937-3.png||height="629" width="544"]]
12 12  
13 +[[image:image-20240424145824-1.gif]][[image:image-20240424145847-2.jpeg||height="359" width="478"]]
14 +
13 13  = 3.OTA UART flash =
14 14  
15 15  Open the OTA_Tool folder and put the latest firmware "layout.bin" and "output. img" into the img folder.
... ... @@ -26,7 +26,7 @@
26 26  
27 27  2 Select an upgrade mode. AIS supports serial port upgrade only. Press 2 to select Uart protocol
28 28  
29 -3 Select a port number. For example, the serial port number is COM17. Press 1 to select COM17
31 +3 Select a port number. Choose the largest number of serial port, For example, here shows 16 and 17. Press 1 to select COM17
30 30  
31 31  4 Select the baud rate. The default baud rate is 921600. Press 14 to select 921600
32 32  
image-20240424145824-1.gif
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.karry
Size
... ... @@ -1,0 +1,1 @@
1 +1.5 MB
Content
image-20240424145847-2.jpeg
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.karry
Size
... ... @@ -1,0 +1,1 @@
1 +3.1 MB
Content
image-20240424145937-3.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.karry
Size
... ... @@ -1,0 +1,1 @@
1 +2.2 MB
Content