Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -1,5 +3,3 @@
1		-
2		-
3	3	**Table of Contents:**
4	4
5	5	{{toc/}}
...	...	@@ -8,7 +8,7 @@
8	8
9	9
10	10
11		-= LoRaST v4 base Hardware =
	9	+= 1. LoRaST v4 base Hardware =
12	12
13	13	Below hardware use LoRaST v4 module. They module support UART Access for AT Command and Firmware Upgrade.
14	14
...	...	@@ -18,10 +18,12 @@
18	18	**PS-LB **
19	19	)))|(% style="width:135px" %)SIB|(% style="width:199px" %)Instruction|(% style="width:230px" %)Instruction
20	20
21		-= UART for AT Commands =
22	22
23		-== Generate software set up for AT Commands via UART ==
24	24
	21	+= 2. UART for AT Commands =
	22	+
	23	+== 2.1 Generate software set up for AT Commands via UART ==
	24	+
25	25	1. Use a general serial tool.
26	26	1. Connect PC to device's UART interface
27	27	1. Set up serial tool with : BaudRate: 9600, databit:8, No parity, No flow control.
...	...	@@ -29,15 +29,15 @@
29	29	[[image:image-20221224170218-1.png||height="497" width="640"]]
30	30
31	31
32		-== UART Connection for SIB mother board ==
	32	+== 2.2 UART Connection for SIB mother board ==
33	33
34	34	[[image:image-20221224171304-3.png||height="545" width="863"]]
35	35
36	36
37	37
38		-= UART for Firmware Upgrade =
	38	+= 3. UART for Firmware Upgrade =
39	39
40		-== General Instruction for UART update firmware ==
	40	+== 3.1 General Instruction for UART update firmware ==
41	41
42	42	LoRaSTv4 Base hardware support UART update firmware. the UART connection is the same as AT Command connection, with the need for two extra action. See below for the steps:
43	43
...	...	@@ -63,7 +63,7 @@
63	63	[[image:image-20221224174341-4.png||height="471" width="374"]]
64	64
65	65
66		-== UART Connection for SIB mother board for Program. ==
	66	+== 3.2 UART Connection for SIB mother board for Program. ==
67	67
68	68	Below shows the SIB board UART connection, reset button and BOOT Switch (Program Jumper) position. They can be used for firmware upgrade reference.
69	69