Mydevices
Table of Contents：
- 1. Setup Gateway to connect to Mydevices
- 2. Route a TTN End Node to Cayenne
- 3. Create Alarm event in Cayenne
1. Setup Gateway to connect to Mydevices
1.1 Introduction
The Dragino LoRaWAN gateway amd end node can commuicate with Mydevices LoRaWAN Network Server: Mydevices
1.2 Gateway Registered
Step 1: Get the GWID of the gateway and set the correct service address
Configure the gateway
Step 2: Select Gateway in the mydevice console
Select Gateway
Step 3: Registered gateway for mydevice
Registered gateway for mydevice
1.3 Check Gateway connection
Users can check if the gateway is properly connected according to 'Satus' or check the gateway WEB like below
Check Status1
Check statis2
1.4 Check Gateway traffic from Mydevie
user can see the gateway traffic
Gateway trafiic
1.5 Add up End node for mydevice
Step 1 : Create a device in TTN with the OTAA keys from LT IO controller. Each end node is shipped with a sticker with the default device EUI as below:
User can enter this key in their LoRaWAN Server portal. Below is mydevice screen shot: Add APP EUI in the application.
Add App EUI
Add APP KEY and DEV EUI
Add App key and App DEUI
Step 2 : Power on end node and it will auto join to the TTN network. After join success, it will start to upload message to Mydevice and user can see in the panel and analyze the data
Join mydevice of end node
2. Route a TTN End Node to Cayenne
Step 1: Add a webhooks
Step 2：Choose Cayenne
Step 3：Successfully created webhooks
Step 4：Add new Device in Cayenne
Step 5： Select TTN
Step 6：Select the device you need
Step 7：Enter Deveui and Location
Step 8：Complete connection
3. Create Alarm event in Cayenne
Step 1: Select widget to alarm，Click settings in the upper right corner - trigger
Step 2：Set your trigger and alarm address
Step 3：When an alarm occurs, it will be sent to your email or mobile phone
