Skip to Content
Last modified by Mengting Qiu on 2025/06/18 15:53
From version 141.10
edited by Mengting Qiu
on 2025/06/16 10:14
Change comment: There is no comment for this version
To version 142.1
edited by Mengting Qiu
on 2025/06/16 10:15
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1029,12 +1029,9 @@
1029 1029  (% style="color:red" %)**For example, the HEX-format downlink command corresponding to AT+TDC can only be used to configure TDC and cannot be used for queries. There is no HEX-format downlink command equivalent to AT+TDC=? , so querying TDC via downlink is not supported.**
1030 1030  
1031 1031  
1032 +**Template for Batch Configuration:**
1032 1032  
1033 -
1034 -Json：
1035 -
1036 -The Json format in MQTT mode needs to be configured with all commands.
1037 -If you have configurations that need to be changed, please change them in the template below.
1034 +We can also use templates to configure multiple commands AT once. Users only need to modify the parameters of the required AT commands in the correct template for each device.
1038 1038  Template:
1039 1039  
1040 1040  {
... ... @@ -1060,16 +1060,18 @@
1060 1060  "AT+TEMPALARM3":"0"
1061 1061  }
1062 1062  
1063 -Hex：
1060 +**Instructions for Using the Template:**
1064 1064  
1065 -MQTT's hex format. Since many commands need to support strings, only a few commands are supported.
1062 +1. Modify the parameters for each AT command in the template as needed.
1063 +1. Send the entire template in one downlink command.
1066 1066  
1067 -The supported commands are consistent with LoRaWAN's hex commands.
1068 -Please refer to the following link to obtain the hex format:
1065 +(% style="color:red" %)**Note:**
1069 1069  
1070 -[[http:~~/~~/wiki.dragino.com/xwiki/bin/view/Main/End%20Device%20AT%20Commands%20and%20Downlink%20Command/>>http://wiki.dragino.com/xwiki/bin/view/Main/End%20Device%20AT%20Commands%20and%20Downlink%20Command/]]
1067 +* The template may vary depending on the device model.
1068 +* **Currently, each specific template is being updated and tested**. If you need a template for your specific device, please contact **Dragino Technical Support** at [[support@dragino.com>>url:https://mailto:support@dragino.com/]] to request the latest downlink template.
1071 1071  
1072 1072  
1071 +
1073 1073  == 7.4 What if the signal is good but the domain name resolution fails? ==
1074 1074  
1075 1075