Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -3,7 +3,6 @@
3	3	{{toc/}}
4	4
5	5
6		-
7	7	= 1. Introduction =
8	8
9	9	Dragino LoRaWAN End Node support two types of AT Commands and Downlink Commands:
...	...	@@ -20,10 +20,9 @@
20	20
21	21	* For AT Command , See Devices User Manual for Device. The user manual can be found in each product page of [[Dragino Official Website>>url:http://www.dragino.com/]]
22	22	* For LoRaWAN Downlink: The gateway transfer downlink command in HEX format. This page shows the HEX format downlink code for each command. but some servers use base64 as downlink code. Below are reference for how to use downlink command:
23		-** Use HEX format to send a downlink: [[TTN v3>>doc:Main.Notes for TTN.WebHome]]
24		-** Use HEX format to send a downlink: [[test>>Notes for TTN]]
25		-** Use Base64 format to send a downlink: [[Chirpstack>>doc:Main.Notes for ChirpStack.WebHome]].
26		-** See use note for more serves [[Servers Note>>doc:Main.WebHome]](IoT LoRaWAN Server)
	22	+** Use HEX format to send a downlink: [[TTN v3>>url:https://wiki.dragino.com/index.php/Notes_for_TTN#Send_Downlink_message]]
	23	+** Use Base64 format to send a downlink: [[Chirpstack>>url:https://wiki.dragino.com/index.php/Notes_for_ChirpStack#Downlink]].
	24	+** See use note for more serves [[Servers Note>>url:https://wiki.dragino.com/index.php/Main_Page#Use_Note_for_Server]]
27	27
28	28	= 3. Support End Node and firmware version =
29	29
...	...	@@ -171,8 +171,6 @@
171	171
172	172	(((
173	173	If the downlink payload=**04FF**, the end node will reboot.
174		-
175		-
176	176	)))
177	177
178	178	== 4.3 Reset to factory Default ==
...	...	@@ -794,7 +794,7 @@
794	794
795	795	)))
796	796
797		-== 7.11 Receive Delay2 ==
	793	+== 7.11Receive Delay2 ==
798	798
799	799	Feature: Get or Set the delay between the end of the Tx and the Rx Window 2 in ms
800	800
...	...	@@ -999,8 +999,6 @@
999	999
1000	1000	(((
1001	1001	Increasing thisvalue is equal to extending the time that the receiving window is opened, butthe corresponding power consumption will also increase. Properly increasingthis value can increase the success rate of the downlink.
1002		-
1003		-
1004	1004	)))
1005	1005
1006	1006	== 7.21 Get or Set RXwindows2 timeout ==