Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -123,9 +123,13 @@
123	123	**Downlink Command: 0x01**
124	124	{{/info}}
125	125
	126	+(((
126	126	Format: Command Code (0x01) followed by 3 bytes time value.
	128	+)))
127	127
	130	+(((
128	128	If the downlink payload=0100003C, it means set the END Node’s Transmit Interval to 0x00003C=60(S), while type code is 01.
	132	+)))
129	129
130	130	* **Example 1**: Downlink Payload:** 0100001E** ~/~/ Set Transmit Interval (TDC) = 30 seconds
131	131	* **Example 2**: Downlink Payload:** 0100003C** ~/~/ Set Transmit Interval (TDC) = 60 seconds
...	...	@@ -220,7 +220,9 @@
220	220
221	221	Downlink Format: 0x26
222	222
	227	+(((
223	223	Device will reply with firmware version info, device info. frequency band info. detail please check device user manual. Total 5 bytes Example: If device is of firmware version 1.1.0 Upload: xx ~-~- yy ~-~- zz ~-~- 110 total 5 bytes
	229	+)))
224	224
225	225	**xx: Software Type:**
226	226
...	...	@@ -965,11 +965,15 @@
965	965	)))
966	966	|(% style="width:163px" %)AT+RX1WTO=60|(% style="width:201px" %)Set RXwindows1 timeout|(% style="width:93px" %)OK
967	967
968		-AT+RX1TWO is theRxSingle timeout value of receive window 1. If it is not set, then the queriedvalue is the default value. If it is set, then the queried value is the setvalue. AT+RX2TWO is thesame as above. The definitionof RxSingle timeout is as described in the following paragraph.
	974	+(((
	975	+**AT+RX1TWO** is theRxSingle timeout value of receive window 1. If it is not set, then the queriedvalue is the default value. If it is set, then the queried value is the setvalue. AT+RX2TWO is thesame as above. The definitionof RxSingle timeout is as described in the following paragraph.
	976	+)))
969	969
970	970	[[image:image-20220511120050-1.png]]
971	971
	980	+(((
972	972	Increasing thisvalue is equal to extending the time that the receiving window is opened, butthe corresponding power consumption will also increase. Properly increasingthis value can increase the success rate of the downlink.
	982	+)))
973	973
974	974	== 7.21 Get or Set RXwindows2 timeout ==
975	975