Changes for page Instruction for LA66 Peer to Peer firmware
Last modified by Bei Jinggeng on 2022/12/19 11:05
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -15,7 +15,7 @@ 15 15 == 1. AT command: == 16 16 17 17 18 - **(% style="color:blue" %)1) Lora parameter configuration:**18 +(% style="color:blue" %)**1) Lora parameter configuration:** 19 19 20 20 AT+FRE: Get or Set TX and RX frequency 21 21 ... ... @@ -38,7 +38,7 @@ 38 38 AT+SYNCWORD: Get or Set sync word 39 39 40 40 41 - **(% style="color:blue" %)2) General configuration:**41 +(% style="color:blue" %)**2) General configuration:** 42 42 43 43 ATZ: Trig a reset of the MCU 44 44 ... ... @@ -63,27 +63,27 @@ 63 63 == 2. Serial port information == 64 64 65 65 66 - **(% style="color:blue" %)1) Information initialized at reset:**66 +(% style="color:blue" %)**1) Information initialized at reset:** 67 67 68 68 [[image:image-20220926112125-1.png]] 69 69 70 70 71 - **(% style="color:blue" %)2) In retransmission, the Uplinkcounter does not accumulate. The following figure shows that the third count packet is retransmitted twice when the ACK packet is not received.**71 +(% style="color:blue" %)**2) In retransmission, the Uplinkcounter does not accumulate. The following figure shows that the third count packet is retransmitted twice when the ACK packet is not received.** 72 72 73 73 74 74 [[image:image-20220926112125-2.png]] 75 75 76 76 77 - **(% style="color:blue" %)3) In the figure below, the receiver sends an ACK to the sender after receiving the packet, and the sender stops retransmission after receiving the ACK.**77 +(% style="color:blue" %)**3) In the figure below, the receiver sends an ACK to the sender after receiving the packet, and the sender stops retransmission after receiving the ACK.** 78 78 79 79 80 - **(% style="color:red" %)Receiver: (configured as AT+RXMOD=65535,2)**80 +(% style="color:red" %)**Receiver: (configured as AT+RXMOD=65535,2)** 81 81 82 82 [[image:image-20220926112125-3.png]] 83 83 84 84 85 85 86 - **(% style="color:red" %)Sender:**86 +(% style="color:red" %)**Sender:** 87 87 88 88 [[image:image-20220926112125-4.png]] 89 89 ... ... @@ -105,7 +105,6 @@ 105 105 106 106 107 107 108 - 109 109 = AT Command Set. = 110 110 111 111 == Set TX and RX Bandwidth ==