Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -8,6 +8,7 @@
8	8	**PS-LB **
9	9	)))|(% style="width:135px" %)SIB|(% style="width:199px" %)Instruction|(% style="width:230px" %)Instruction
10	10
	11	+
11	11	= UART for AT Commands =
12	12
13	13	== Generate software set up for AT Commands via UART ==
...	...	@@ -27,37 +27,4 @@
27	27
28	28	= UART for Firmware Upgrade =
29	29
30		-== General Instruction for UART update firmware ==
31		-
32		-LoRaSTv4 Base hardware support UART update firmware. the UART connection is the same as AT Command connection, with the need for two extra action. See below for the steps:
33		-
34		- **Step1**: Set BOOT Switch to **PROG** mode. PROG mode is for update firmware specially.
35		-
36		- **Step2**: Press **Reset** button, the module will then boot into program mode.
37		-
38		- **Step3**: Use **TremoProgrammer** to update the firmware to LoRaST v4.
39		-
40		- **Step4**: Set BOOT Switch to **FLASH** position. Press Reset button again and module will run the new software.
41		-
42		-
43		-Below is the method for how to update via **TremoProgrammer:**
44		-
45		-1.  Software download link:  [[https:~~/~~/www.dropbox.com/sh/j0qyc7a9ejit7jk/AACtx2tK4gEv6YFXMIVUM4dLa?dl=0>>url:https://www.dropbox.com/sh/j0qyc7a9ejit7jk/AACtx2tK4gEv6YFXMIVUM4dLa?dl=0]]
46		-
47		-2.  Run** TremoProgrammer.**
48		-
49		-3.  Choose software and set the address to **0x0800D000**
50		-
51		-4. Rember to set BOOT Switch to FLASH after update
52		-
53		-[[image:image-20221224174341-4.png||height="471" width="374"]]
54		-
55		-
56		-== UART Connection for SIB mother board for Program. ==
57		-
58		-Below shows the SIB board UART connection, reset button and BOOT Switch (Program Jumper) position. They can be used for firmware upgrade reference.
59		-
60		-[[image:image-20221224174605-6.png||height="569" width="880"]]
61		-
62		-
63	63