Changes for page End Device AT Commands and Downlink Command
Last modified by Mengting Qiu on 2024/06/05 10:57
Summary
-
Page properties (1 modified, 0 added, 0 removed)
Details
- Page properties
-
- Content
-
... ... @@ -991,7 +991,7 @@ 991 991 **AT+RX1TWO** is theRxSingle timeout value of receive window 1. If it is not set, then the queriedvalue is the default value. If it is set, then the queried value is the setvalue. AT+RX2TWO is thesame as above. The definitionof RxSingle timeout is as described in the following paragraph. 992 992 ))) 993 993 994 -[[image:image-2022051 1120050-1.png]]994 +[[image:image-20220526162535-1.png]] 995 995 996 996 ((( 997 997 Increasing thisvalue is equal to extending the time that the receiving window is opened, butthe corresponding power consumption will also increase. Properly increasingthis value can increase the success rate of the downlink. ... ... @@ -1088,6 +1088,7 @@ 1088 1088 * **AT+ADR=0 **~-~-> Disable ADR first 1089 1089 * **AT+RX2DR=xxxx** ~-~-> Set xxxx to your wanted DataRate 1090 1090 1091 + 1091 1091 == 8.2 Use Downlink Command to set a fix uplink DR == 1092 1092 1093 1093 {{info}} ... ... @@ -1096,6 +1096,6 @@ 1096 1096 1097 1097 Same as: 1098 1098 1099 -* AT+ADR=0 [[Reference>> http://8.211.40.43:8080/xwiki/bin/view/End%20Device%20AT%20Commands%20and%20Downlink%20Command/#H7.1AdaptiveDataRate]]1100 -* AT+DR=5 [[Reference>> http://8.211.40.43:8080/xwiki/bin/view/End%20Device%20AT%20Commands%20and%20Downlink%20Command/#H7.4DataRate]]1101 -* AT+TXP=0 [[Reference>> http://8.211.40.43:8080/xwiki/bin/view/End%20Device%20AT%20Commands%20and%20Downlink%20Command/#H7.14TransmitPower]]1100 +* AT+ADR=0 [[Reference>>||anchor="H7.1AdaptiveDataRate"]] 1101 +* AT+DR=5 [[Reference>>||anchor="H7.4DataRate"]] 1102 +* AT+TXP=0 [[Reference>>||anchor="H7.14TransmitPower"]]