Table of Contents:

1. Prepare Hardware & Software

2. Hardware Connection

The AIS Sensors and AUC USB TTL Adapter for AIS Sensors are connected and then connected to the PC.

image-20240428155042-1.pngimage-20240527163351-2.png

image-20240424145824-1.gifimage-20240424145847-2.jpeg

3. OTA UART flash

Open the OTA_Tool folder and put the latest firmware "layout.bin" and "output. img" into the img folder.

1713510920220-760.png

The OTA_Tool folder should be opened and the program can be run by double-clicking on ota.exe.

1713511385474-910.png

When the program opens, follow these steps.

1 Select the chip type. AIS uses QFN72. Press 2 to select QFN72

2 Select an upgrade mode. AIS supports serial port upgrade only. Press 2 to select Uart protocol

3 Select a port number.The instance device port number is 17.Press 1 to select COM17

4 Select the baud rate. The default baud rate is 921600. Press 14 to select 921600

1713511914316-181.png

After the baud rate is configured, the upgrade page is displayed. 1 is to check whether the communication port is correct.

1713513351848-254.pngx

Select 1 to check whether the configured port is correct.

1713513373484-487.png

Select 2 is port is after normal communication with AIS.

1713513478607-793.png

Press 0, press Enter, and select 2 to go to the upgrade surface.

1713513522820-547.png

1713513544122-175.png

Select 2 to enter the upgrade.

1713513668777-698.png

If ReBoot WEI is displayed as shown in the following figure, the upgrade succeeds.

1713513732175-702.png